I installed Lubuntu on Virtualbox. I'm using Windows 7 x64. My VM is 32 bit version. The internet works using Bridged Adapter, but I'm trying to use NAT so I can use a VPN. In Network and Sharing Center in Windows, I see connection "VirtualBox Host-Only Connection" and it says "No Internet Access". In properties, "VirtualBox Bridged Networking Driver" is checked. The following is the output of ifconfig:
dev@dev-VirtualBox:~$ ifconfigeth0 Link encap:Ethernet HWaddr 08:00:27:f3:48:24 inet addr:10.0.2.15 Bcast:10.0.2.255 Mask:255.255.255.0 inet6 addr: fe80::a00:27ff:fef3:4824/64 Scope:Link UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:379 errors:0 dropped:0 overruns:0 frame:0 TX packets:421 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:32105 (32.1 KB) TX bytes:34987 (34.9 KB)lo Link encap:Local Loopback inet addr:127.0.0.1 Mask:255.0.0.0 inet6 addr: ::1/128 Scope:Host UP LOOPBACK RUNNING MTU:65536 Metric:1 RX packets:856 errors:0 dropped:0 overruns:0 frame:0 TX packets:856 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:0 RX bytes:56432 (56.4 KB) TX bytes:56432 (56.4 KB)Routing Table:
dev@dev-VirtualBox:~$ routeKernel IP routing tableDestination Gateway Genmask Flags Metric Ref Use Ifacedefault 10.0.2.2 0.0.0.0 UG 0 0 0 eth010.0.2.0 * 255.255.255.0 U 1 0 0 eth0dev@dev-VirtualBox:~$ Connection Editor:General: Automatically Connect to this network when it isn't available, All users may connect ot this networkEthernet: MTU automaticIPV4: Automatic (DHCP), Require ipv4 addressing for this connection to completeIPV6: Ignore
dev@dev-VirtualBox:~$ cat /etc/network/interfaces# interfaces(5) file used by ifup(8) and ifdown(8)auto loiface lo inet loopback